                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2758962
GamePi by araymbox is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

Check out the new version with joysticks:
https://www.thingiverse.com/thing:2809128

This a simple sleek shell to create a raspberry pi based portable game station. 
It was designed around a 5" Elecrow Display and a Raspberry Pi 3. 

I've added two versions of the shell:
1st: Front and back cover are made from one part (fits fine on a 21x21cm bed)
2nd: Front and back cover are split into 3 parts each (for smaller printers)

For the build shown in the pictures I've use the following parts:
- 5" Display (https://www.amazon.de/gp/product/B013JECYF2)
- Raspberry Pi 3 (https://www.amazon.de/dp/B01CD5VC92)
- microSD Card 64GB (https://www.amazon.de/gp/product/B073SB2L3C)
- Power (Electronics/Batteries) (https://www.amazon.de/gp/product/B00XTVOAQM)
- Stereo Amp 2x1,5W (https://www.ebay.de/itm/271513588858)
- Soft Tactile Switches (https://www.amazon.de/gp/product/B01JD3H5RK)
- Buttons from an old Controller
- 3,5mm switched Stereo Jack 
- small 1,5W Speakers from an old notebook
- other small parts and cables

You can leave a tip (button left) if you like my stuff. 


# Print Settings

Printer: Anet A8
Rafts: No
Supports: No
Resolution: 0.2
Infill: 40%