.:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2765181
Z-probe bracket for Duplicator i3 Plus with Diiicooler by ppardee is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

This is an inductive z-probe mount for an 18mm inductive sensor on the Duplicator i3 Plus with  a Diiicooler installed.  This mounts between the extruder fan and heatsink, replacing those spacers that fall into the case every time you remove the fan.

The spacers are not a precision part, but you'll want to make sure the mounts are roughly the same size once printed and sand them down to about 9.3mm if they are too large

# Print Settings

Printer Brand: Wanhao
Printer: Wanhao Duplicator i3 Plus
Rafts: No
Supports: Doesn't Matter
Resolution: 0.2
Infill: 100%

Notes: 
Since this sits very close to the heater block, it should be printed in a high-temperature filament such as PETG.  If you don't use supports, you may have to drill out the screw holes to allow for clear passage