.:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:2485151
Nintendo Switch Arcade Cabinet by concavechest is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

A stand for the Nintendo Switch in the form of a miniature arcade cabinet.

Bond all components EXCEPT the Top. The Top is made to slide on/off in order to insert/remove the Nintendo Switch Console.

For one cabinet, one of each of the following is required:
-Top
-Simple Bottom and Front
-Simple Cradle
-Simple Back
-Left Side
-Right Side
-Filler

*I have received feedback that for some versions of the Switch firmware, the hub components did not work as intended, but I have also seen comments stating that as of ver. 7.0.0, there is not a problem. Some have voiced their concerns about third-party devices bricking Switch consoles, though I have not heard of that happening with this system. Use the hub components at your own discretion*

For one cabinet with electronic components for charging, one of each of the following is required:
-Top
-Bottom and Front
-Cradle
-Back
-Left Side
-Right Side
-Filler
-Elbow Retainer
-Fan Duct (optional)

The electronic components used:
-USB C Male to Female Adapter, Right & Left Angled 90 Degree 
-Seadream Panel Mount Dual USB 2.0 Extension Cable
-AC Infinity 80mm USB Fan
-LENTION 4-in-1 USB-C Hub
-Panel Mount USB-C Extension Cable


# Print Settings

Printer Brand: MakerBot
Printer: MakerBot Replicator 2
Rafts: No
Supports: No
Resolution: Standard
Infill: 25

Notes: 
When oriented correctly, supports are not necessary