                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1729078
Cricut Explore Air Fine Sharpie Adapter by fgrinst1 is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

This part was designed to allow use of a fine-tipped Sharpie pen with the Cricut Explore air. It is based on the OEM Cricut pen adapter, with slight dimensional changes.

Notes: 
- Be sure to prime the pen (scribbling on a piece of scrap paper) before starting the job, otherwise the first few cm will not have ink (as seen in picture).
- The weight of the line can be changed by adjusting material thickness dial on the Cricut. The picture shown has the dial set to "Paper" (second thinnest).

# Print Settings

Printer Brand: Printrbot
Printer: Simple Black
Rafts: Yes
Supports: No
Resolution: .3mm
Infill: 100%

Notes: 
Printed with leaf spring fingers pointing upwards. File takes ~1 hr at .3mm resolution

# Post-Printing

Some light scraping with an exacto knife may be required to clean up part.

# How I Designed This

Originally designed in Solidworks, part migrated to Fusion 360.